Location of data files
If you would like LionClock 2011 data to be stored in a different location on your hard drive or network, you can select a different location where you would like the data folder to be copied. The data includes employee info, time files, program settings, etc. By default, the data is stored in a folder named "program_data" located in the folder where LionClock 2011 was installed.
If you change the default location and can no longer start LionClock 2011, please follow these steps to restore the original configuration:
1) Go to the folder where LionClock 2011 was installed. Usually "C:\Program Files\LionClock\".
2) Inside, you will see a file named "redirect.cfg". Delete this file.
3) There, you will also see a backup of your original data folder that looks like that "data_backup_dd_yyyy". Change the name of this folder to "program_data" (with an underscore).
4) When you start LionClock 2011, it should be using the data files from the original, default location.
Titles
LionClock 2011's interface is available in English only and cannot be adapted to another language. However, you may want to adjust the titles of most important buttons and labels if your worker's language is not English. The drop-down boxes on this tab allow you to select titles in English, French and Spanish. You can also enter any other translation you like. Please note that this affects the titles of most important buttons and labels only. Payroll reports remain 100% English.